PSC FALCON 315 Guia do Utilizador descarregar pdf (Página 70)

The Falcon Dock

Falcon

DOS Portable Terminals

1. Attach the small, round plug of the power adapter to the power

input jack on the back of the Falcon Dock (refer to

Figure 24).

2. Plug the other end into an outlet or power strip.

3. The red light-emitting diode (LED) labeled

POWER on the front

panel of the Falcon Dock should light up.

The power adapter is used only to recharge the batteries in the Falcon

31X

32X.

•The

Ready light indicates that the Falcon is properly inserted in the

dock.

•The

Ready light appears red when charging and green when fully

charged.

In the Falcon

33X and 34X, the dock’s power must be on for serial commu-

nication to occur.

Using the Falcon Dock

Set up the Falcon Dock as described in the preceding sections. Refer to

Chapter 9 for information on troubleshooting problems with the Falcon

Dock.

1. Place the Falcon into the dock, with the keypad facing the front.

2. If a power adapter is being used, the green LED labeled

Ready on

the front panel of the Falcon Dock lights up.

While the Falcon is in its dock:

• Programs can be downloaded into the Falcon or data returned from

it just as if it were connected directly to the computer.

• The Falcon can be left in the dock while using an attached bar code

reader.

• The Falcon Dock can be used to recharge either nickel-cadmium

(NiCD) or nickel metal hydride (NiMH) battery packs.

The LED indicators on the Falcon Dock will not light up if the power adaptor

is not used. Serial communications will operate normally even though the

indicator LEDs will remain dark without the adapter.

2314.book Page 60 Friday, July 12, 2002 1:42 PM

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 99 100

Sem comentários

PSC FALCON 315 Guia do Utilizador Página 70