PSC LINEAR IMAGER 7000 Manual de Serviço descarregar pdf (Página 24)

16 PowerScan® 7000BT SRI

• the scanner is linked to the desired Base Station. See "Linking the

Scanner to a Base Station" on page 5

• the scanner is within reasonable operating range of the Base Sta-

tion, with no major obstructions between the radio units such as

thick walls or heavy machinery. (At the time of this writing, maxi-

mum scanner-to-Base Station range is specified at 100 meters.)

• the Base Station is powered-on. When the Base Station powers up,

both LEDs briefly flash. If both lights are bright and crisp, this is a

good indication of adequate power input from the AC Adapter.

• the Base Station interface cable is securely attached to the host.

Consult your technical support manager or refer to your host sys-

tem manual to identify the proper cable connection for the scan-

ner. If necessary, verify interface cable function by using a known-

good interface cable.

Troubleshooting the Scanner

If the problem is specific to scanning, verify that...

• The scanner will automatically perform a set of self-tests whenever

you turn it on. Observe and note any special indications made by

the scanner (an unexpected pattern of flashes or beeps) during

power-up. If technical support is contacted regarding a problem,

they may request this information.

• Does the scanner power on? Does the illumination beam come on?

If no illumination beam, check that...

• the battery has been adequately charged.

• the battery is fully seated and its latch engaged.

•the trigger works.

• Is the scanner having trouble reading your symbols?

If the scanner isn’t reading symbols well, check that the symbols...

• aren’t smeared, rough, scratched, or exhibiting voids.

• aren’t coated with frost or water droplets on the surface.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Sem comentários

PSC LINEAR IMAGER 7000 Manual de Serviço Página 24