PSC PT Program Generator Manual do Utilizador descarregar pdf (Página 5)

5 of 30

Tutorial –detailed version.

Prerequisites.

1. Install PT40 Dock and XFER32 program.

2. Install “iporeceive” and ipoupdate programs into TurningPoint.

3. Install custom version of Open PO Report.

4. The Tutorial assumes you have read this entire document.

Instructions for installation of the PT40, XFER32, and custom reports and programs are in this

document. See “Installation of Hardware and Software” in the table of contents.

Your PT40 comes with two i-PO Receive programs loaded on it. If for any reason you need to

re-install these programs see “Re-Installing i-PO Receive on the PT40”.

The program files are included on the i-PO Receive CD.

This tutorial is based on TurningPoint Sample Company 2. We added some units of measure to

the original data to better illustrate some of the advanced capabilities.

We created PO 002785

1 2 3 4 5 6 7 8 9 10 ... 29 30

Sem comentários

PSC PT Program Generator Manual do Utilizador Página 5